Add config for the 1st module
This commit is contained in:
parent
7839671bf8
commit
5777094a28
@ -14,17 +14,17 @@
|
||||
|
||||
// Enable the temperatue and pressure Sensor BMP180
|
||||
// (CONFIG_BMP180_SDA and CONFIG_BMP180_SDA should be defined as well)
|
||||
#define CONFIG_ENABLE_BMP180
|
||||
#define CONFIG_BMP180_SDA 12
|
||||
#define CONFIG_BMP180_SCL 14
|
||||
//#define CONFIG_ENABLE_BMP180
|
||||
//#define CONFIG_BMP180_SDA 12
|
||||
//#define CONFIG_BMP180_SCL 14
|
||||
|
||||
#define CONFIG_ENABLE_DHT
|
||||
#define CONFIG_DHT_PIN 2
|
||||
#define CONFIG_DHT_TYPE DHT22
|
||||
#define CONFIG_DHT_PIN 14
|
||||
#define CONFIG_DHT_TYPE DHT11
|
||||
|
||||
//#define CONFIG_ENABLE_DRY_SENSOR
|
||||
#define CONFIG_ENABLE_DRY_SENSOR
|
||||
//If the dry sensor is powered by a GPIO, this GPIO could be defined here
|
||||
//#define CONFIG_DRY_POWER_PIN 13
|
||||
#define CONFIG_DRY_POWER_PIN 12
|
||||
|
||||
// Enable light sleep to save some power (http://bbs.espressif.com/viewtopic.php?f=6&t=133&p=485&hilit=sleep+modem#p485)
|
||||
#define CONFIG_ENABLE_POWER_SAVE
|
||||
@ -38,7 +38,7 @@
|
||||
|
||||
/* DEFAULT VALUE ALSO DEFINED IN CONFIG.H */
|
||||
//If this GPIO is LOW at boot, device will enter setup mode
|
||||
#define CONFIG_SETUP_GPIO 5
|
||||
#define CONFIG_SETUP_GPIO 4
|
||||
|
||||
// Time to sleep between 2 webserver request (increase it reduce battery usage but increase latency)
|
||||
//#define CONFIG_WEB_DELAY_MS 100
|
||||
@ -47,11 +47,11 @@
|
||||
#define CONFIG_SAMPLING_PERIODE_MS 300000
|
||||
|
||||
// Name of the SSID when in AP mode for configuration
|
||||
#define CONFIG_SSID_NAME "ESPConfiguratorBureau"
|
||||
#define CONFIG_SSID_NAME "ESPConfigurator"
|
||||
|
||||
// GPIO that can be set or get by mqtt and set via http
|
||||
// Should have less value than MAXSUBSCRIPTIONS
|
||||
//#define CONFIG_CONTROLLED_GPIO {12,13}
|
||||
#define CONFIG_CONTROLLED_GPIO {13}
|
||||
|
||||
// GPIO that can be get by mqtt and http
|
||||
// Pin 6 to 11 and 16 can not be used for mqtt
|
||||
|
Loading…
Reference in New Issue
Block a user