52 lines
1.6 KiB
C
52 lines
1.6 KiB
C
#pragma once
|
|
|
|
// Enable Serial Console (Disable to save space and power)
|
|
#define CONFIG_SKETCH_DEBUG
|
|
|
|
// Switch Serial console on gpio 13 and 15 (So you can use GPIO 1 and 3 for other things)
|
|
//#define CONFIG_ENABLE_EXTRA_GPIO
|
|
|
|
// Enable the temperatue and pressure Sensor BMP180
|
|
// (CONFIG_BMP180_SDA and CONFIG_BMP180_SDA should be defined as well)
|
|
#define CONFIG_ENABLE_BMP180
|
|
#define CONFIG_BMP180_SDA 12
|
|
#define CONFIG_BMP180_SCL 14
|
|
|
|
#define CONFIG_ENABLE_DHT
|
|
#define CONFIG_DHT_PIN 5
|
|
|
|
//#define CONFIG_ENABLE_DRY_SENSOR
|
|
//If the dry sensor is powered by a GPIO, this GPIO could be defined here
|
|
//#define CONFIG_DRY_POWER_PIN 13
|
|
|
|
// Enable light sleep to save some power (http://bbs.espressif.com/viewtopic.php?f=6&t=133&p=485&hilit=sleep+modem#p485)
|
|
#define CONFIG_ENABLE_POWER_SAVE
|
|
|
|
// Disable mDNS can also save power
|
|
#define CONFIG_ENABLE_MDNS
|
|
|
|
//Web controlled GPIO
|
|
#define CONFIG_WEB_CONTROLLED_GPIO 2
|
|
|
|
|
|
/* DEFAULT VALUE ALSO DEFINED IN CONFIG.H */
|
|
//If this GPIO is LOW at boot, device will enter setup mode
|
|
//#define CONFIG_SETUP_GPIO 3
|
|
|
|
// Time to sleep between 2 webserver request (increase it reduce battery usage but increase latency)
|
|
//#define CONFIG_WEB_DELAY_MS 100
|
|
|
|
// Get sensors value every X ms
|
|
//#define CONFIG_SAMPLING_PERIODE_MS 60000
|
|
|
|
// Name of the SSID when in AP mode for configuration
|
|
//#define CONFIG_SSID_NAME "ESPConfigurator"
|
|
|
|
// GPIO that can be set or get by mqtt
|
|
// Should have less value than MAXSUBSCRIPTIONS
|
|
#define CONFIG_MQTT_CONTROLLED_GPIO {2,13}
|
|
|
|
// EEPROM SIZE
|
|
// Max is 4096, but this amount will be allocated in RAM for reading its content
|
|
//#CONFIG_EEPROM_SIZE 256
|