WifiControlSensor/BME680.h

@@ -14,6 +14,8 @@
 //Use Default i2c pin GPIO4(D2): SDA, GPIO5(D1):SCL
 
 #define SEALEVELPRESSURE_HPA (1013.25)
+#include <SFE_BMP180.h>
+#include "debug_sketch.h"
 
 int BME680GetMeasure(float &t, float &p, float &h, float &g, float &a);
 int BME680Setup();

WifiControlSensor/SCD4X.h

@@ -1,23 +0,0 @@
-#pragma once
-#ifdef CONFIG_ENABLE_SCD4X
-#include "debug_sketch.h"
-
-int SCD4XGetMeasure(float &t, float &h, uint16_t &co2);
-int SCD4XSetup();
-bool SCD4XIsConnected();
-
-#else
-int SCD4XGetMeasure(float &, float &, uint16_t &)
-{
-        return -1;
-};
-int SCD4XSetup()
-{
-        SKETCH_DEBUG_PRINTLN("SCD4X is disabled at build time");
-        return -1;
-};
-bool SCD4XIsConnected()
-{
-        return false;
-};
-#endif

WifiControlSensor/SCD4X.ino

@@ -1,61 +0,0 @@
-#ifdef CONFIG_ENABLE_SCD4X
-#include "SCD4X.h"
-#include <Arduino.h>
-#include <SensirionI2CScd4x.h>
-#include <Wire.h>
-
-SensirionI2CScd4x scd4x;
-
-int SCD4XConnected = 0;
-
-int SCD4XSetup()
-{
-    Wire.begin();
-    scd4x.begin(Wire);
-
-    // Stop previous measurement
-    uint16_t error = scd4x.stopPeriodicMeasurement();
-    if (error) {
-        SKETCH_DEBUG_PRINTLN("Cannot connect to SCD4X");
-        return -1;
-    }
-
-    // Start new measurement
-    error = scd4x.startPeriodicMeasurement();
-    if (error) {
-        SKETCH_DEBUG_PRINTLN("Cannot start measurement for SCD4X");
-        return -1;
-    }
-    SCD4XConnected = 1;
-
-    return 0;
-}
-int SCD4XGetMeasure(float &temperature, float &humidity, uint16_t &co2)
-{
-    // Read Measurement
-    bool isDataReady = false;
-
-    uint16_t error = scd4x.getDataReadyFlag(isDataReady);
-    if (error) {
-        SKETCH_DEBUG_PRINTLN("Error trying to execute getDataReadyFlag() for SCD4X ");
-        return -1;
-    }
-    if (!isDataReady) {
-        return -1;
-    }
-    error = scd4x.readMeasurement(co2, temperature, humidity);
-    if (error || co2 == 0) {
-        char errorMsg[256];
-        SKETCH_DEBUG_PRINT("Error with reading measurement. Error : ");
-        errorToString(error, errorMsg, sizeof(errorMsg));
-        SKETCH_DEBUG_PRINTLN(" Co2: %d", co2);
-
-        return -1;
-    }
-    return 0;
-}
-bool SCD4XIsConnected()
-{
-    return SCD4XConnected != 0;
-}
-#endif