Correct SETUP gpio as already used by sensor

WifiControlSensor/config_device.h

@@ -14,13 +14,12 @@
 
 // Enable the temperatue and pressure Sensor BMP180 
 // (CONFIG_BMP180_SDA and CONFIG_BMP180_SDA should be defined as well)
-#define CONFIG_ENABLE_BMP180
-#define CONFIG_BMP180_SDA 12
-#define CONFIG_BMP180_SCL 14
-
-#define CONFIG_ENABLE_DHT
-#define CONFIG_DHT_PIN 2
-#define CONFIG_DHT_TYPE DHT22
+//#define CONFIG_ENABLE_BMP180
+//#define CONFIG_BMP180_SDA 12
+//#define CONFIG_BMP180_SCL 14
+//
+//#define CONFIG_ENABLE_DHT
+//#define CONFIG_DHT_PIN 5
 
 //#define CONFIG_ENABLE_DRY_SENSOR
 //If the dry sensor is powered by a GPIO, this GPIO could be defined here
@@ -38,7 +37,7 @@
 
 /* DEFAULT VALUE ALSO DEFINED IN CONFIG.H */
 //If this GPIO is LOW at boot, device will enter setup mode
-#define CONFIG_SETUP_GPIO 5
+#define CONFIG_SETUP_GPIO 3
 
 // Time to sleep between 2 webserver request (increase it reduce battery usage but increase latency)
 //#define CONFIG_WEB_DELAY_MS 100
@@ -47,15 +46,15 @@
 #define CONFIG_SAMPLING_PERIODE_MS 300000
 
 // Name of the SSID when in AP mode for configuration
-#define CONFIG_SSID_NAME "ESPConfiguratorBureau"
+#define CONFIG_SSID_NAME "ESPConfigurator"
 
 // GPIO that can be set or get by mqtt and set via http
 // Should have less value than MAXSUBSCRIPTIONS
-//#define CONFIG_CONTROLLED_GPIO {12,13}
+#define CONFIG_CONTROLLED_GPIO {2}
 
 // GPIO that can be get by mqtt and http
 // Pin 6 to 11 and 16 can not be used for mqtt
-//#define CONFIG_OBSERVED_GPIO {5}
+#define CONFIG_OBSERVED_GPIO {5}
 
 // GPIO used in PWM
 //#define CONFIG_CONTROLLED_PWM {}